Siemens SINAMICS G120 Manual page 412

Parameters
List of Parameters
p20096 ADD 0 run-time group / ADD 0 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance ADD 0 of the adder is to be called.
Value: 5:
6:
9999: Do not calculate
p20097 ADD 0 run sequence / ADD 0 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance ADD 0 within the run-time group set in p20096.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20098[0...3] CI: ADD 1 inputs / ADD 1 inputs
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 1 of the adder.
Index: [0] = Input X0
[1] = Input X1
[2] = Input X2
[3] = Input X3
r20099 CO: ADD 1 output Y / ADD 1 output Y
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 1 of the adder.
p20100 ADD 1 run-time group / ADD 1 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance ADD 1 of the adder is to be called.
Value: 5:
6:
9999: Do not calculate
1-412
Run-time group 5
Run-time group 6
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
210
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
0
Data type: FloatingPoint32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
© Siemens AG 2011 All Rights Reserved