Siemens SINAMICS G120 Manual page 404

Parameters
List of Parameters
p20062[0...3] BI: XOR 0 inputs / XOR 0 inputs
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantities I0, I1, I2, I3 of instance XOR 0 of the XOR function block.
Index: [0] = Input I0
[1] = Input I1
[2] = Input I2
[3] = Input I3
r20063 BO: XOR 0 output Q / XOR 0 output Q
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for binary quantity Q of instance XOR 0 of the XOR function block.
p20064 XOR 0 run-time group / XOR 0 RTG
Access level: 3
Can be changed: T
Units group: -
Min
1
Description: Setting parameter for the run-time group in which the instance XOR 0 of the XOR function block is to be called.
Value: 1:
2:
3:
4:
5:
6:
9999: Do not calculate
p20065 XOR 0 run sequence / XOR 0 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance XOR 0 within the run-time group set in p20064.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
1-404
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
110
© Siemens AG 2011 All Rights Reserved