Siemens SINAMICS G120 Manual page 150

Parameters
List of Parameters
p1141[0...n] BI: Continue ramp-function generator/freeze ramp-function generator / Continue RFG
CU230P-2 DP Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the command "continue ramp-function generator/freeze ramp-function generator".
For the PROFIdrive profile, this command corresponds to control word 1 bit 5 (STW1.5).
BI: p1141 = 0 signal:
Freezes the ramp-function generator.
BI: p1141 = 1 signal:
Continues the ramp-function generator.
Dependency: Refer to: r0054, p1140, p1142
Caution: When "master control from PC" is activated, this binector input is ineffective.
Notice: The ramp-function generator is, independent of the state of the signal source, active in the following cases:
- OFF1/OFF3.
- ramp-function generator output within the suppression bandwidth.
- ramp-function generator output below the minimum speed.
p1142[0...n] BI: Enable setpoint/inhibit setpoint / Setpoint enable
CU230P-2 CAN Access level: 3
CU230P-2 HVAC
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the command "enable setpoint/inhibit setpoint".
For the PROFIdrive profile, this command corresponds to control word 1 bit 6 (STW1.6).
BI: p1142 = 0 signal
Inhibits the setpoint (the ramp-function generator input is set to zero).
BI: p1142 = 1 signal
Enables the setpoint.
Dependency: Refer to: p1140, p1141
Caution: When "master control from PC" is activated, this binector input is ineffective.
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
1-150
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: U32 / Binary
Data set: CDS, p0170
Factory setting
[0] 2090.5
[1] 1
[2] 2090.5
[3] 2090.5
Data type: U32 / Binary
Data set: CDS, p0170
Factory setting
1
© Siemens AG 2011 All Rights Reserved