Siemens SINAMICS G120 Manual page 233

p1901 Test pulse evaluation configuration / Test puls config
Access level: 4
Can be changed: T
Units group: -
Min
-
Description: Sets the configuration for the test pulse evaluation.
Re bit 00:
Check for conductor-to-conductor short circuit when pulse is enabled.
Bit field: Bit Signal name
00 Phase short-circuit test pulse active
Note: Re bit 00:
If the test was successful once after POWER ON (see r1902.0), it is not repeated.
If a conductor-to-conductor short-circuit is detected during the test, this is displayed in r1902.1.
r1902 Test pulse evaluation status / Test puls ev stat
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Displays the status of the test pulse evaluation.
Short-circuit test:
Bit 0: The short-circuit test was run without any faults detected.
Bit 1: A phase short circuit has been detected.
Bit field: Bit Signal name
00 Short-circuit test executed
01 Phase short-circuit detected
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Parameters
List of Parameters
Data type: Unsigned32
Data set: -
Factory setting
0000 bin
0 signal
No
Data type: Unsigned32
Data set: -
Factory setting
-
0 signal
No
No
FP
-
FP
-
-
1-233