Siemens SINAMICS G120 Manual page 84

Parameters
List of Parameters
p0651[0...n] Motor operating hours maintenance interval / Mot t_op maint
Access level: 3
Can be changed: T
Units group: -
Min
0 [h]
Description: Sets the service/maintenance intervals in hours for the appropriate motor.
An appropriate fault is output when the operating hours set here are reached.
Dependency: Refer to: p0650
Refer to: A01590
Note: For p0651 = 0, the operating hours counter is disabled.
The operating hours counter only runs with drive data set 0 and 1 (DDS).
p0700[0...n] Command source selection / Cmd src sel
CU230P-2 CAN Access level: 1
Can be changed: T
Units group: -
Min
0
Description: Sets the command source.
Value: 0:
2:
100:
101:
110:
120:
140:
150:
152:
181:
182:
183:
184:
200:
Caution: When executing a specific macro, the corresponding programmed settings are made and become active.
1-84
No Macro
Terminals
EAQ1
EAQ2
Set enable signals
FBM (fault, operation, signal)
CDS
MOP 1
MOP 3
2 Wire type 2
2 Wire type 3
3 Wire type 1
3 Wire type 2
CAN Control
Calculated: -
Scaling: -
Unit selection: -
Max
150000 [h]
Calculated: -
Scaling: -
Unit selection: -
Max
200
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Unsigned32
Data set: MDS
Factory setting
0 [h]
Data type: Integer16
Data set: CDS, p0170
Factory setting
0
© Siemens AG 2011 All Rights Reserved