Siemens SINAMICS G120 Manual page 315

p2378 Staging/De-staging speed / Stag/Destag speed
Access level: 3
Can be changed: T
Units group: -
Min
0.0 [%]
Description: Sets the speed for the main drive, which is approached directly after an external motor has been connected or dis-
connected (staging/de-staging).
The parameter value refers to the maximum speed (p1082).
r2379.0...7 CO/BO: Staging status word / Staging ZSW
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the status word for the staging function.
Bit field: Bit Signal name
00 Start external motor 1
01 Start external motor 2
02 Start external motor 3
03 Staging enabled
04 Staging/De-staging active
05 All motors active
06 AutoChange not possible
07 Staging alarm active
p2380[0...2] Staging operating hours / Staging op_hrs
Access level: 3
Can be changed: U, T
Units group: -
Min
0.0 [h]
Description: Displays the operating hours for the external motors.
The display can only be reset to zero.
Index: [0] = Motor 1
[1] = Motor 2
[2] = Motor 3
p2381 Staging time limit for continuous operation / Stag t_max cont
Access level: 3
Can be changed: U, T
Units group: -
Min
0.1 [h]
Description: Time limit for the continuous operation of external motors.
Continuous operation is measured starting from when a motor is connected to the line voltage. It ends when a
motor is disconnected from the line.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
100.0 [%]
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
340.28235E36 [h]
Calculated: -
Scaling: -
Unit selection: -
Max
100000.0 [h]
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
50.0 [%]
Data type: Unsigned32
Data set: -
Factory setting
-
0 signal
No
No
No
No
No
No
No
No
Data type: FloatingPoint32
Data set: -
Factory setting
0.0 [h]
Data type: FloatingPoint32
Data set: -
Factory setting
24.0 [h]
FP
-
-
-
-
-
-
-
-
1-315