Siemens SINAMICS G120 Manual page 408

Parameters
List of Parameters
r20079 BO: NOT 0 inverted output / NOT 0 inv output
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the inverted output of instance NOT 0 of the inverter.
p20080 NOT 0 run-time group / NOT 0 RTG
Access level: 3
Can be changed: T
Units group: -
Min
1
Description: Setting parameter for the run-time group in which the instance NOT 0 of the inverter is to be called.
Value: 1:
2:
3:
4:
5:
6:
9999: Do not calculate
p20081 NOT 0 run sequence / NOT 0 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance NOT 0 within the run-time group set in p20080.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20082 BI: NOT 1 input I / NOT 1 input I
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantity I of instance NOT 1 of the inverter.
r20083 BO: NOT 1 inverted output / NOT 1 inv output
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the inverted output of instance NOT 1 of the inverter.
1-408
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
160
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: Unsigned32
Data set: -
Factory setting
-
© Siemens AG 2011 All Rights Reserved