Siemens SINAMICS G120 Manual page 334

Parameters
List of Parameters
r3930[0...4] Power unit EEPROM characteristics / PU characteristics
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the characteristics (A5E number and versions) of the power unit.
[0]: A5E number xxxx (A5Exxxxyyyy)
[1]: A5E number yyyy (A5Exxxxyyyy)
[2]: File version (logistic)
[3]: File version (fixed data)
[4]: File version (calib data)
p3950 Service parameter / Serv. par.
Access level: 3
Can be changed: C, U, T
Units group: -
Min
-
Description: For service personnel only.
r3974 Drive unit status word / Drv_unit ZSW
Access level: 1
Can be changed: -
Units group: -
Min
-
Description: Displays the status word for the drive unit.
Bit field: Bit Signal name
00 Software reset active
01 Writing of parameters disabled as parame-
ter save in progress
02 Writing of parameters disabled as macro is
running
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4
Can be changed: -
Units group: -
Min
-
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
1-334
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Unsigned16
Data set: -
Factory setting
-
Data type: Unsigned16
Data set: -
Factory setting
-
Data type: Unsigned32
Data set: -
Factory setting
-
0 signal
No
No
No
Data type: Unsigned32
Data set: -
Factory setting
-
© Siemens AG 2011 All Rights Reserved
FP
-
-
-