Siemens SINAMICS G120 Manual page 236

Parameters
List of Parameters
r1912[0...2] Identified stator resistance / R_stator ident
Access level: 4
Can be changed: -
Units group: -
Min
- [ohm]
Description: Displays the identified stator resistance.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
r1913[0...2] Identified rotor time constant / T_rotor ident
Access level: 4
Can be changed: -
Units group: -
Min
- [ms]
Description: Displays the identified rotor time constant.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
r1914[0...2] Identified total leakage inductance / L_total_leak ident
Access level: 4
Can be changed: -
Units group: -
Min
- [mH]
Description: Displays the identified total leakage inductance.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
r1915[0...2] Identified nominal stator inductance / L_stator ident
Access level: 4
Can be changed: -
Units group: -
Min
- [mH]
Description: Displays the nominal stator inductance identified.
Index: [0] = Phase U
[1] = Phase V
[2] = Phase W
1-236
Calculated: -
Scaling: -
Unit selection: -
Max
- [ohm]
Calculated: -
Scaling: -
Unit selection: -
Max
- [ms]
Calculated: -
Scaling: -
Unit selection: -
Max
- [mH]
Calculated: -
Scaling: -
Unit selection: -
Max
- [mH]
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: FloatingPoint32
Data set: -
Factory setting
- [ohm]
Data type: FloatingPoint32
Data set: -
Factory setting
- [ms]
Data type: FloatingPoint32
Data set: -
Factory setting
- [mH]
Data type: FloatingPoint32
Data set: -
Factory setting
- [mH]
© Siemens AG 2011 All Rights Reserved