Siemens SINAMICS G120 Manual page 469

r31024 CO: Multi-zone control setpoint output / Zone_ctrl set outp
Access level: 2
Can be changed: -
Units group: -
Min
- [%]
Description: Displays the relevant setpoint at the multi-zone control output.
p31025 BI: Multi-zone control day/night switchover / Zone_ctl day_night
Access level: 2
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the day/night multi-zone control switchover.
p31026[0...2] CI: Multi-zone control actual-value input / Zon_ctrl act inp
Access level: 2
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the multi-zone control actual values.
r31027 CO: Multi-zone control actual-value output / Zon_ctrl act outp
Access level: 2
Can be changed: -
Units group: -
Min
- [%]
Description: Displays the relevant actual value at the multi-zone control output.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
- [%]
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
- [%]
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
0
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
1-469