Siemens SINAMICS G120 Manual page 411

p20092 NOT 3 run-time group / NOT 3 RTG
Access level: 3
Can be changed: T
Units group: -
Min
1
Description: Setting parameter for the run-time group in which the instance NOT 3 of the inverter is to be called.
Value: 1:
2:
3:
4:
5:
6:
9999: Do not calculate
p20093 NOT 3 run sequence / NOT 3 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance NOT 3 within the run-time group set in p20092.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20094[0...3] CI: ADD 0 inputs / ADD 0 inputs
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 0 of the adder.
Index: [0] = Input X0
[1] = Input X1
[2] = Input X2
[3] = Input X3
r20095 CO: ADD 0 output Y / ADD 0 output Y
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 0 of the adder.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Parameters
List of Parameters
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
190
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
0
Data type: FloatingPoint32
Data set: -
Factory setting
-
1-411