Siemens SINAMICS G120 Manual page 425

p20161 PDE 0 run-time group / PDE 0 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which instance PDE 0 of the closing delay device is to be called.
Value: 5:
6:
9999: Do not calculate
p20162 PDE 0 run sequence / PDE 0 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance PDE 0 within the run-time group set in p20161.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20163 BI: PDE 1 input pulse I / PDE 1 inp_pulse I
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for the input pulse I of instance PDE 1 of the closing delay device.
p20164 PDE 1 pulse delay time in ms / PDE 1 t_del ms
Access level: 3
Can be changed: T
Units group: -
Min
0.00
Description: Setting parameter for pulse delay time T in milliseconds of instance PDE 1 of the closing delay device.
r20165 BO: PDE 1 output Q / PDE 1 output Q
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for output pulse Q of instance PDE 1 of the closing delay device.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
60000.00
Calculated: -
Scaling: -
Unit selection: -
Max
-
Parameters
List of Parameters
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
430
Data type: U32 / Binary
Data set: -
Factory setting
0
Data type: FloatingPoint32
Data set: -
Factory setting
0.00
Data type: Unsigned32
Data set: -
Factory setting
-
1-425