Siemens SINAMICS G120 Manual page 452

Parameters
List of Parameters
r20309 CO: ADD 2 output Y / ADD 2 output Y
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 2 of the adder.
p20310 ADD 2 run-time group / ADD 2 RTG
Access level: 3
Can be changed: T
Units group: -
Min
5
Description: Setting parameter for the run-time group in which the instance ADD 2 of the adder is to be called.
Value: 5:
6:
9999: Do not calculate
p20311 ADD 2 run sequence / ADD 2 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run sequence of instance ADD 2 within the run-time group set in p20310.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20312[0...1] CI: NCM 0 inputs / NCM 0 inputs
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantities X0 and X1 of instance NCM 0 of the numeric comparator.
Index: [0] = Input X0
[1] = Input X1
r20313 BO: NCM 0 output QU / NCM 0 output QU
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for binary quantity QU of instance NCM 0 of the numeric comparator.
QU is only set if X0 > X1.
1-452
Run-time group 5
Run-time group 6
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: FloatingPoint32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
800
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
0
Data type: Unsigned32
Data set: -
Factory setting
-
© Siemens AG 2011 All Rights Reserved