Control Units Cu230P; Function Diagrams; Sinamics G120 Control Units Cu230P-2 Parameter Manual (Lh9) - Siemens SINAMICS G120 Manual

Table 1-8
Unit group
Description
Explanation of the parameter function.
Values
List of possible parameter values.
Recommendation
Information about recommended settings.
Index
The name and meaning of each individual index is specified for indexed parameters, except
indexed parameters which belong to a data set (see "Data Set").
Bit array
For parameters with bit arrays, for each bit the following information is provided:
• Bit number and signal name
• Meaning at signal states 0 and 1
• Function diagram (FP) (optional). The signal is shown on this function diagram.
Dependency
Conditions which need to be fulfilled with regard to this parameter. This also includes special
effects which can occur between this parameter and others.
© Siemens AG 2011 All Rights Reserved

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011

Unit group (p11226)
Unit selection for p11226 =
Value
9_4 The values that can be set and the technological units are shown in
p11226 (see Chapter 1.2).
Introduction to Parameters
Reference value
at %
Unit
Parameters
1-15