Siemens SINAMICS G120 Manual page 434

Parameters
List of Parameters
r20204 BO: DFR 1 output Q / DFR 1 output Q
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for output Q of instance DFR 1 of the D flipflop.
r20205 BO: DFR 1 inverted output QN / DFR 1 inv outp QN
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Display parameter for the inverted output QN of instance DFR 1 of the D flipflop.
p20206 DFR 1 run-time group / DFR 1 RTG
Access level: 3
Can be changed: T
Units group: -
Min
1
Description: Setting parameter for the run-time group in which instance DFR 1 of the D flipflop is to be called.
Value: 1:
2:
3:
4:
5:
6:
9999: Do not calculate
p20207 DFR 1 run sequence / DFR 1 RunSeq
Access level: 3
Can be changed: T
Units group: -
Min
0
Description: Setting parameter for the run-time group of instance DFR 1 within the run-time group set in p20206.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20208[0...1] BI: BSW 0 inputs / BSW 0 inputs
Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source of input quantities I0 and I1 of instance BSW 0 of the binary changeover switch.
Index: [0] = Input I0
[1] = Input I1
1-434
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
9999
Calculated: -
Scaling: -
Unit selection: -
Max
32000
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: Integer16
Data set: -
Factory setting
9999
Data type: Unsigned16
Data set: -
Factory setting
560
Data type: U32 / Binary
Data set: -
Factory setting
0
© Siemens AG 2011 All Rights Reserved