Siemens SINAMICS G120 Manual page 389

p11193 Free tec_ctrl 1 limit ramp-up/ramp-down time / Ftec1 lim r-u/r-dn
Access level: 3
Can be changed: U, T
Units group: -
Min
0.00 [s]
Description: Sets the ramp-up and ramp-down time for the maximum and minimum limit (p11191, p11192) of the free technol-
ogy controller 1.
Dependency: Refer to: p11191, p11192
Note: The ramp-up/ramp-down times are referred to 100%.
r11194 CO: Free tec_ctrl 1 output signal / Ftec1 out_sig
Access level: 2
Can be changed: -
Units group: -
Min
- [%]
Description: Display and connector output for the output signal of the free technology controller 1.
p11197 CI: Free tec_ctrl 1 limit maximum signal source / Ftec1 lim max s_s
Access level: 3
Can be changed: U, T
Units group: -
Min
-
Description: Sets the signal source for the maximum limit of the free technology controller 1.
Dependency: Refer to: p11191
p11198 CI: Free tec_ctrl 1 limit minimum signal source / Ftec1 lim min s_s
Access level: 3
Can be changed: U, T
Units group: -
Min
-
Description: Sets the signal source for the minimum limit of the free technology controller 1.
Dependency: Refer to: p11192
p11199 CI: Free tec_ctrl 1 limit offset signal source / Ftec1 lim offs
Access level: 3
Can be changed: U, T
Units group: -
Min
-
Description: Sets the signal source for the limit offset of the free technology controller 1.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
100.00 [s]
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
- [%]
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Parameters
List of Parameters
Data type: FloatingPoint32
Data set: -
Factory setting
1.00 [s]
Data type: FloatingPoint32
Data set: -
Factory setting
- [%]
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
11191[0]
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
11192[0]
Data type: U32 / FloatingPoint32
Data set: -
Factory setting
0
1-389