Siemens SINAMICS G120 Manual page 335

p3981 Faults, acknowledge drive object / Faults ackn DO
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Setting to acknowledge all active faults of a drive object.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgement, the parameter is automatically reset to 0.
p3985 Master control mode selection / PcCtrl mode select
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Sets the mode to change over the master control / LOCAL mode.
Value: 0:
1:
Danger: When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986 Parameter count / Parameter No.
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency: Refer to: r0980, r0981, r0989
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Change master control for STW1.0 = 0
Change master control in operation
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
-
Parameters
List of Parameters
Data type: Unsigned8
Data set: -
Factory setting
0
Data type: Integer16
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
Factory setting
-
1-335