Config Stpd Ports Mode - Extreme Networks ExtremeWare Command Reference Manual

config stpd ports mode

config stpd <spanning tree name> ports mode {dot1d | emistp | pvst-plus}
[<portlist>]
Description
Configures the STP mode of operation for the specified port list.
Syntax Description
spanning tree name
dot1d
emistp
pvst-plus
portlist
Default
Ports in the default STPD (s0) are
Usage Guidelines
None.
Example
The following command configures STPD s1 with PVST+ packet formatting for port 1 on a stand-alone
switch:
config stpd s1 ports mode pvst-plus 1
The following command configures STPD s1 with PVST+ packet formatting for slot 2, port 1 on a
modular switch:
config stpd s1 ports mode pvst-plus 2:1
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies an STPD name on the switch.
Specifies IEEE 802.1d-compliant packet formatting. A physical port can only
be a member of one STPD running it dot1d mode.
Specifies 802.1d formatting and 802.1q tagging.
Specifies PVST+ packet formatting.
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
mode. Ports in user-created STPDs are in
dot1d
config stpd ports mode
mode.
emistp
711