Configure Security-Profile Wep Key Add - Extreme Networks ExtremeWare Command Reference Manual

configure security-profile wep key add

configure security-profile <name> wep key add <index> [hex <hexoctet> |
plaintext <string>]
Description
Adds the given WEP key at the specified index.
Syntax Description
name
index
hexoctet
string
Default
Hexadecimal
Usage Guidelines
This key is used for WEP encryption. If you use
digits. (That is, if encryption-length is 64, the key should be 10 hexadecimal digits (64-24 (ICV) = 40bits
= 5 bytes = 10 hexadecimal digits.) When you specify
value of the letters in the specified key (for example, A = 35 and so on...). Plaintext does not mean
passphrase.
Configuration changes take effect immediately and are propagated to all ports sharing the named
profile. If the command fails, none of the changes is propagated to any of the ports.
Examples
The following example adds the first WEP key (0) with the hexadecimal encryption code 1234567891:
configure security-profile wep-secure wep key add 0 hex 1234567891
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e and to the "i"
series in 7.3.0.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p, and Alpine 3800
switches.
ExtremeWare 7.5 Command Reference Guide
Specifies the names of the security profile.
Specifies the index. Valid values are 0-3.
Specifies to use the hexadecimal value as the WEP key.
Specifies a plain text value as the WEP key.
mode, the key should be made up of hexadecimal
hex
mode, the key is simply the ASCII
plaintext
configure security-profile wep key add
903