Configure Access-Profile Mode - Extreme Networks ExtremeWare Command Reference Manual

Security Commands

configure access-profile mode

configure access-profile <access profile> mode [permit | deny | none]
Description
Configures the access profile mode to permit or deny access, or to require per-entry access control.
Syntax Description
access profile Specifies an access profile name.
permit Allows the addresses that match the access profile description.
deny Denies the addresses that match the access profile description.
none Permits and denies access on a per-entry basis. Each entry must be added to the profile as
either type permit or deny.
Default
Permit
Usage Guidelines
The access list mode determines whether the items in the list are to be permitted access or denied
access.
Example
The following command configures the access profile no_subnet_33 to deny access:
configure access-profile no_subnet_33 mode deny
The following command specifies that the access profile no_subnet_33 uses per-entry access control:
configure access-profile no_subnet_33 mode none
History
This command was first available in ExtremeWare 4.0.
The per-entry access control was added in ExtremeWare 6.1.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
836 ExtremeWare 7.5 Command Reference Guide