Create Access-Profile Type - Extreme Networks ExtremeWare Command Reference Manual

create access-profile type

For the "i" series switches:
create access-profile <access profile> type [ipaddress | ipx-node | ipx-net
| ipx-sap | as-path | bgp-community | vlan]
For the "e" series switches:
create access-profile <access profile> type [ipaddress | as-path]
Description
Creates an access profile.
Syntax Description
access profile
ipaddress
ipx-node
ipx-net
ipx-sap
as-path
bgp-community
vlan
Default
N/A
Usage Guidelines
You must give the access profile a unique name, in the same manner as naming a VLAN, protocol filter,
or spanning tree domain.
After the access profile is created, you must configure the access profile mode. The access profile mode
determines whether the items in the list are to be permitted access or denied access.
For version 4.0 (not on the Summit 400 switch):
• Only type
• On BlackDiamond 6800 MSM32 running ExtremeWare 4.1, the VLAN keyword specifies that profile
entries will be a list of VLANs.
ExtremeWare 7.5 Command Reference Guide
Specifies an access profile name.
Specifies that the profile entries will be a list of IP address/mask pairs.
Specifies that the profile entries will be a list of IPX node addresses.
NOTE: This option is available only on the "e" series switches.
Specifies that the profile entries will be a list of IPX NetIDs.
NOTE: This option is available only on the "e" series switches.
Specifies that the profile entries will be a list of IPX SAP advertisements.
NOTE: This option is available only on the "e" series switches.
Specifies that the profile entries will be a list of AS path expressions.
Specifies that the profile entries will be a list of BGP community numbers.
NOTE: This option is available only on the "i" series switches.
Specifies that the profile entries will be a list of VLANs.
NOTE: This option is available only on the BlackDiamond 6800 MSM32 running
ExtremeWare 4.1.
was supported, and the
ipaddress
keyword was not used.
type
create access-profile type
943