Confirming Ip Addresses - Brocade Communications Systems Brocade 300 Administrator's Manual

2
Installing and running the EZSwitchSetup wizard
5. If you are setting up the switch for the first time, the addresses shown are not valid. If you click
6. Click Next.

Confirming IP addresses

The Confirm IP Address window
using either a serial connection or an Ethernet connection.
14
FIGURE 9
Set Switch IP Address window
NOTE
Beginning at step 5, the steps are the same for both serial and Ethernet connections.
Next with these addresses in place, EZSwitchSetup returns an error window.
To set up IPv4 addresses, edit the address information on the Set Switch IP Address window to
create static addresses appropriate for your LAN connection.
To set up IPv6 addresses, enter the IPv6 address and prefix in the spaces provided.
EZSwitchSetup attempts to log in using default credentials. If you have already changed your
admin password, you will be prompted to enter your new password.
Proceed to "Confirming IP addresses" on page 14.
(Figure 10) is displayed after you have assigned IP addresses,
EZSwitchSetup Administrator's Guide
53-1002744-01