Viewing Ip Addresses; Switch Configuration; Enabling And Disabling A Switch - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

1. Open the Switch Administration window as described in
2. Select the Blade tab.
3. Click Set IP address.
4. Select a slot number from the list.
5. Enter the IP address, subnet mask, and Gateway IP address.
6. Select a type from the list.
7.
8. Click Apply to save the values currently shown in the table or click Cancel to close the dialog
9. To update the switch with your changes, update the table using the Add and Delete buttons,

Viewing IP addresses

If you want to view the IP addresses configured on the switch for the currently populated slots, use
the Show IP Address button.
Use this procedure to display the IP addresses.
1. Open the Switch Administration window as described in
2. Select the Blade tab.
3. Click Show IP Address.
4. Scroll through the list to view all the information.
5. When you are finished, click Close.

Switch configuration

Use the Switch tab of the Switch Administration window to perform basic switch configuration.
Figure 8

Enabling and disabling a switch

You can identify whether a switch is enabled or disabled in the Switch Administration window by
looking at the lower-right corner. If you rest the cursor over the icon, the system displays text that
indicates the status of the switch.
Use this procedure to enable or disable a switch.
Web Tools Administrator's Guide
53-1002756-01
window" on page 31.
Click Add to add the new entry to the table.
When you click Add, the values remain in the fields. The Clear Gateway and Clear IP buttons
are available for clearing fields in the table.
NOTE
To remove a configuration, select a row in the table and click Delete.
box without saving any of your changes.
and then click Apply.
window" on page 31.
on page 30 displays an example of the Switch tab.

Switch configuration

"Opening the Switch Administration
"Opening the Switch Administration
3
35