Touch-Tone Or Rotary Signaling - Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features

Touch-Tone or Rotary Signaling

Touch-Tone or Rotary Signaling
At a Glance
Users Affected
Reports Affected
Modes
Telephones
System Programming
Factory Settings
DID
Loop-Start/Ground-Start
Tie
Rotary Signaling
Description
Touch-tone, tip/ring devices, such as single-line telephones or fax machines, are
equipped with a dialpad that generates dual-tone multifrequency (DTMF) signals
when a dial button is pressed. Analog multiline and MLX telephones are equipped
with dialpads that generate digitally coded signals when a dial button is pressed.
The duration of the signal sent is 50 milliseconds (50 ms) and is not adjustable.
A touch-tone receiver (TTR) is required either to make calls from tip/ring
equipment or to use the Remote Access feature. TTRs are provided on 400, 400
GS/LS, 800 DID, 008 OPT, 800 GS/LS-ID, 016, and 012 modules. Normally,
these TTRs are sufficient to handle the calls originated from these modules.
However, additional TTRs may be needed to support the following services:
Tie trunks and DS1-emulated tie trunks set for DTMF signaling
Remote Access
Account Code Entry
Authorization Codes
Telephone users, operators
DID Trunk Information, GS/LS Trunk Information, System
Information (
SysSet-up
All
All
Change individual line/trunk to rotary or touch-tone service:
LinesTrunks TT/LS Disc
Change individual tie trunk to rotary or touch-tone service:
LinesTrunks TIE Lines
Change individual tie trunk to rotary or touch-tone service:
LinesTrunks TIE Lines
Change DID trunk block to rotary or touch-tone signaling:
LinesTrunks DID
Change rotary signaling:
More
Options
Rotary
Touch-tone
Rotary
Delay
4 0
4 0
), Tie Trunk Information
Outmode
Inmode
Outmode
Signaling
Rotary Delay/No Delay
4 0
Issue 1
June 1997
Page 598