Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference page 246

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features
Direct Station Selector: MLX
Saved Number Dial
Signal/Notify
System
Renumbering
Transfer
An extension dialed by pressing a DSS button is not stored for Saved
Number Dial.
If a user presses a Signal button programmed with an operator's
extension while making a call to the operator, the LED next to the DSS
button associated with the user changes from flashing to on while the
Signal button is held down.
The beginning extension number for each page is assigned through
system programming. The factory settings are as follows: Page 1 button
begins with Extension 0, Page 2 button begins with Extension 50, and
Page 3 button begins with Extension 100.
The Transfer option of one-touch Hold applies only to outside calls on a
DLC and not to calls on a QCC. When one-touch Hold is programmed
and an operator presses a DSS button with an inside caller on the line (or,
in Hybrid/PBX mode, with an outside caller on an SA button), the call is
not put on hold and a signal is sent to the extension corresponding to the
DSS button pressed. When one-touch Transfer (with either manual or
automatic completion) is programmed and an operator presses the DSS
button while the caller is on the line and no SA or ICOM button is
available to transfer the call, the call does not go on hold. If the operator
hangs up, the caller is disconnected.
Transfer is always initiated and transfer completion is manual when an
operator presses the DSS button corresponding to a line/trunk number,
pool dial-out code (Hybrid/PBX only), or ARS access code (Hybrid/PBX
only), even if one-touch Hold, one-touch Transfer with automatic
completion (DLC only), or automatic extended call completion (QCC only)
is programmed for the system.
When an operator transfers an Individual or Group Coverage call and the
call returns, the red LED next to the DSS button for the sender does not
flash as it does for a transfer return for calls received on other types of
line buttons.
When an operator transfers a call to a calling group and the call returns,
the red LED associated with the calling group does not flash as it does for
a transfer return from a user's extension.
Issue 1
June 1997
Page 214