Recall/Timed Flash - Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features

Recall/Timed Flash

Recall/Timed Flash
At a Glance
Users Affected
Reports Affected
Modes
Telephones
Programming Codes
Recall
Conference
Drop
Transfer
Feature Code
MLX Display Label
System Programming
Factory Setting
Recall Timer
Description
Recall sends a momentary signal called a timed flash or switchhook flash while
the phone is on the hook. A timed flash is used as a control signal, as follows:
On an inside call, the signal is intercepted by the control unit.
— A multiline telephone user can use Recall to disconnect a call and get a
— A single-line telephone user can use Recall to put an active call on hold
On an outside call, when the system is using host switch services such as
Centrex, the signal may be sent to the host, depending on the type of
telephone and system operating mode.
A multiline telephone user can use Recall to access host features. The
user can be connected to another party or can be listening to outside dial
tone, ringback, or a busy signal.
A single-line telephone user can use Recall to access host services only if
the system is programmed for Behind Switch mode.
Telephone users, DLC operators
Extension Information, System Information (
All
All except QCC
*775
(Behind Switch mode only)
*772
(Behind Switch mode only)
*773
(Behind Switch mode only)
*774
775
Recall [Recll]
Change timed-flash duration (recall timer):
Options
Program fixed Conference, Drop, and Transfer buttons to
access host features in Behind Switch mode:
Options
Transfer
450 ms (options 350 ms, 450 ms, 650 ms, 1 sec)
new dial tone without hanging up. The user can be on an active call or
listening to ringback or dial tone. When the user is listening to a busy
signal, Recall has no effect.
and to access system features such as Conference and Transfer.
3 7
3 7
More
RecallTimer
More
BehndSwitch
3 7
Issue 1
June 1997
Page 511
)
SysSet-up
Conference/Drop/