Toll Type - Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features

Toll Type

Toll Type
At a Glance
Users Affected
Reports Affected
Modes
Telephone
System Programming
Factory Setting
Description
The Toll Type setting allows the system to classify calls as either local or toll,
based on the number a user dials. The factory setting for Toll Type requires a user
to dial a toll prefix (
a toll call. In some areas, a toll prefix is not necessary. The factory setting for Toll
Type can be changed to specify that no toll prefix is required for these types of
lines/trunks.
Dialing a prefix depends on local telephone company requirements and the type
of line/trunk being used.
Considerations and Constraints
Toll Type does not apply to tie trunks or Direct Inward Dial (DID) trunks. The local
telephone company must be consulted to determine which of the system's
lines/trunks require a toll prefix.
Mode Differences
Hybrid/PBX Mode
Systems in Hybrid/PBX mode with Automatic Route Selection (ARS) always
require a user to dial
may require dialing
Telephone users, operators, data users
General Trunk Information
All
All
Designate whether or not a toll prefix is required:
LinesTrunks
Toll prefix required
or ) before dialing the area code and telephone number for
1 0
before dialing a 10-digit toll call. Some 7-digit numbers
1
as well.
1
4 0
4 0
Toll Type
4 0
4 0
4 0
4 0
Issue 1
June 1997
Page 596