Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference page 60

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features
Account Code Entry/Forced Account Code Entry
If Account Code Entry is assigned to a button, the LED flashes when you lift the
handset and attempt an outside call. On MLX display telephones, the feature
name appears on the display. Enter the account code and press the programmed
Account Code Entry button; the green LED goes from flashing to on. Then select
the outside line and proceed with the call.
Single-Line Telephones
Single-line telephones in Behind Switch mode by default cannot use Account
Code Entry or Forced Account Code Entry. If this feature is to be used, the
single-line telephone must be programmed through Idle Line Preference to select
an SA or ICOM button so that the user hears inside dial tone when the handset is
lifted for an outgoing call.
Single-line telephones must have touch-tone dialing to use the Account Code
Entry feature.
When a single-line telephone user hears inside dial tone, the user can activate the
feature by dialing
Single-line telephone users cannot enter account codes by using System Speed
Dial or Personal Speed Dial because these features are activated by dialing
Pressing
activate the Speed Dial features.
Feature Interactions
Authorization Code
Auto Dial
Automatic Line
Selection
Automatic Route
Selection
Callback
Conference
.
#82
completes the entry of an account code and cannot also be used to
#
If an account code is not entered, the ACCOUNT field of the SMDR
printout contains the authorization code used to obtain restriction
privileges. If an account code is entered at any time during a call, the
account code is stored in the SMDR record.
Frequently used account code numbers can be programmed onto outside
Auto Dial buttons.
A single-line telephone user can enter account codes only if Automatic
Line Selection is programmed to select an SA or ICOM button when the
user lifts the handset.
When ARS is used on the system, enter an account code before or after
dialing the telephone number. If Forced Account Code Entry is assigned,
enter the code before dialing the ARS dial-out code.
Enter an account code before activating Callback. Otherwise, the account
code cannot be entered until after the call connects. Account codes
cannot be entered while the call is queued.
Enter a separate account code for each outside call added to a
conference. An account code does not carry over to other calls made at
the same time.
0
0
Issue 1
June 1997
Page 28
.
#