Pools - Lucent Technologies MERLIN LEGEND Release 5.0 Feature Reference

MERLIN LEGEND Communications System Release 5.0
Feature Reference 555-650-110
Features

Pools

Pools
At a Glance
Users Affected
Reports Affected
Modes
Telephones
System Programming
Maximums
Pools for each system
Lines/trunks for each pool
Buttons assigned for each
pool
Factory Settings
Main Pool
Ground-Start Trunk Pool
Dial-In Tie Trunk
Automatic-In Tie Trunk
Pool Dial-Out Code
Restriction
Description
Hybrid/PBX mode allows outside lines/trunks to be grouped together in pools.
Users select lines/trunks by using SA buttons instead of having separate buttons
for each line/trunk in the system. To access pools using SA buttons, people dial
pool dial-out codes. Pools also can be assigned to buttons on one or more
telephones to allow a user to select the pool without dialing the pool dial-out code
or Automatic Route Selection (ARS) access code. In Release 3.1 and later
systems, the factory setting does not allow any extensions to use pool dial-out
codes. To allow a user to access a pool by entering a dial-out code, the system
manager must remove the restriction for the dial-out code and the extension.
When the system is set up and the Hybrid/PBX mode of operation is selected, the
system automatically groups lines/trunks into the following pools:
All loop-start lines (basic and special-purpose) are assigned to the main
pool. The factory-set extension number for the main pool is 70.
All ground-start trunks are assigned to the pool with the factory-set
extension number 890.
Telephone users, operators, data users
Dial Plan Information
Hybrid/PBX only
All
Assign individual lines/trunks to pools:
LinesTrunks Pools
Assign Pool buttons to telephones:
Extensions LinesTrunks
Restrict telephone from using pool dial-out code:
Extensions Dial OutCd
11
Unlimited
64
70
890
891
892
No access to any pool
3 0
3 0
3 0
Issue 1
June 1997
Page 435