Toll Type - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Save your entry.

Select
Enter
Return to the System Programming menu.

Select two times.
Exit

Toll Type

Use this procedure to specify whether users have to dial a toll prefix (1 or 0)
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each line/trunk.)
This setting is used by the system to classify calls as local or long distance so that
appropriate toll restrictions can be applied.
NOTE: NOTE: NOTE:
This option applies only to loop- and ground-start trunks; it does not apply
to tie trunks or DID trunks.
Summary: Toll Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
.
System Manager
All
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Toll prefix required
Required, Not required
No
Yes
LinesTrunks
the line/trunk
To program a block of lines/trunks:
LinesTrunks
lines/trunks
On/Off
Enter
Additional Information
4
4
Select entry mode Dial no. of
Toll Type
Enter Exit Exit
Select block of
Toll Type
Toggle LED
Exit Exit
June 1997
Page 4-40
Exit
Exit
Issue 1
PC