Rscn Commit Vsan - Cisco MDS 9124 - Fabric Switch Reference

rscn commit vsan

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
rscn commit vsan
To apply a pending Registered State Change Notification (RSCN) configuration, use the rscn commit
vsan command in configuration mode. To discard a pending RSCN configuration, use the no form of the
command.
Syntax Description vsan-id
Defaults
None.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
If you commit the changes made to the active database, the configuration is committed to all the switches
in the fabric. On a successful commit, the configuration change is applied throughout the fabric and the
lock is released.
Examples
The following example commits an RSCN configuration on VSAN 1.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# rscn commit vsan 1
Related Commands Command
rscn abort vsan
rscn distribute
rscn event-tov
clear rscn session vsan
show rscn
Cisco MDS 9000 Family Command Reference
20-40
rscn commit vsan vsan-id
no rscn commit vsan vsan-id
Specifies a VSAN where the RSCN configuration should be committed.
The ID of the VSAN is from 1 to 4093.
Modification
This command was introduced.
Description
Cancels a pending RSCN configuration on a specified VSAN.
Enables the distribution of an RSCN configuration.
Configures an RSCN event timeout.
Clears the RSCN session for a specified VSAN.
Displays RSCN configuration information.
Chapter 20
OL-16217-01, Cisco MDS SAN-OS Release 3.x
R Commands