Islb Initiator - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

islb initiator

To configure the iSCSI server load balancing (iSLB) initiator and enter iSLB initiator configuration
submode, use the islb initiator command. To delete the configured ISLB initiator, use the no form of
the command.
Syntax Description ip-address
ip-address
ipv6-address
name name
Defaults None.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines You can use the islb initiator command to enter iSLB initiator configuration submode to configure static
mapping for an iSLB initiator.
Examples
The following example enters iSLB initiator configuration submode to configure static mapping (using
the IPv4 ip-address option) for an iSLB initiator.
switch# config t
switch(config)# islb initiator ipaddress 10.1.2.3
switch(config-islb-init)#
The following example deletes the configured iSLB initiator.
switch(config)# no islb initiator ipaddress 10.1.2.3
The following example enters iSLB initiator configuration submode to configure static mapping (using
the IPv6 option) for an iSLB initiator.
switch# config t
switch(config)# islb initiator ipaddress 1111.2222.3333.4::5
switch(config-islb-init)#
The following example deletes the configured iSLB initiator.
switch(config)# no islb initiator ipaddress 1111.2222.3333.4::5
OL-16217-01, Cisco MDS SAN-OS Release 3.x
islb initiator {ip-address {ip-address | ipv6-address} | name name}
no islb initiator name name
Specifies the iSLB initiator node IP address.
Specifies the initiator IPv4 address.
Specifies the initiator IPv6 address.
Specifies the iSLB initiator node name. The maximum size is 223.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
islb initiator
11-105