Show Santap Module - Cisco MDS 9124 - Fabric Switch Reference

show santap module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show santap module
To display the SANTap configuration on the Storage Services Module (SSM), use the show santap
module command in EXEC mode.
Syntax Description
slot
avt
avtlun
cvt
cvt-id
dvt
dvtlun
rvt
rvtlun
session
session-id
name
brief
tech-support
Defaults
None.
Command Modes EXEC mode.
Command History Release
2.1(1a)
3.1(2)
Usage Guidelines None.
Examples
The following example displays the SANTap AVT configuration.
switch# show santap module 2 avt
AVT Information :
Cisco MDS 9000 Family Command Reference
22-306
show santap module slot {avt [name | brief] | avtlun | cvt [cvt-id | brief] | dvt [name | brief] |
dvtlun | rvt [name | brief] | rvtlun | session [session-id | brief] | tech-support}
Displays SANTap configuration for a module in the specified slot.
Displays the appliance virtual target (AVT) configuration.
Displays the appliance AVT LUN configuration.
Displays the control virtual target (CVT) configuration.
Specifies a user configured CVT ID. The range is 1 to 65536.
Displays the data virtual target (DVT) configuration.
Displays the DVT LUN configuration.
Displays the remote virtual target (AVT) configuration.
Displays the RVT LUN configuration.
Displays the SANTap session information.
Specifies a user configured session ID. The range is 1 to 65536.
Specifies the user name.
Displays a brief format version of the display.
Displays information for technical support.
Modification
This command was introduced.
Added the tech-support option.
avt pwwn = 2a:4b:00:05:30:00:22:25
avt nwwn = 2a:60:00:05:30:00:22:25
avt id = 12
Chapter 22 Show Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x