Iscsi Initiator And Virtual Target Configuration Not Distributed; Islb Configuration, Commit, Or Merge Failed-"Vsan Id Is Not Yet Configured - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 20 Troubleshooting IP Storage Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

iSCSI Initiator and Virtual Target Configuration Not Distributed

Symptom
Table 20-2 iSCSI Initiator and Virtual Target Configuration Not Distributed
Symptom Possible Cause
iSCSI initiator and Normal operation.
virtual target
configuration is not
distributed to the
fabric.
iSLB Configuration, Commit, or Merge Failed—"VSAN ID is Not Yet
Configured"
Symptom
Table 20-3 iSLB Configuration, Commit, or Merge Failed—"VSAN ID is Not Yet Configured."
Symptom Possible Cause
iSLB configuration, The VSAN ID for one of the initiators
commit, or merge is not configured on all switches in the
failed with error fabric.
VSAN
ID is not yet
configured.
OL-9285-05
iSCSI initiator and virtual target configuration is not distributed to the fabric.
iSLB configuration, commit, or merge failed with error
Solution
Only the following iSCSI and iSLB configuration is
distributed:
iSLB initiator and iSLB initiator targets
•
iSLB VRRP load-balancing configuration
•
iSCSI global authentication parameters
•
(authentication algorithm and CHAP user name or
password)
iSCSI dynamic initiator mode (iSCSI, iSLB, or deny)
•
VSAN ID is not yet configured
Solution
Check the output of the show islb cfs-session status, show
islb merge status, and show ips internal event-history
error CLI command for details on which initiator VSAN
ID is not configured on a switch.
Use the vsan database vsan vsan-id CLI command to add
the VSAN ID, or remove the VSAN ID from the initiator
configuration.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
iSLB Issues
.
20-59