Ips Netsim Max-Bandwidth-Kbps - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ips netsim max-bandwidth-kbps

To limit the bandwidth in kilobytes per second of a specified Gigabit Ethernet interface, use the ips
netsim max-bandwidth-kbps command in SAN extension tuner configuration submode.
Syntax Description max-bandwidth-kbps
bandwidth
ingress
gigabitethernet
slot/port
Defaults Disabled.
Command Modes
SAN extension tuner configuration submode.
Command History Release
3.1(1)
Usage Guidelines To use this command, you must enable the IP Network Simulator using the ips netsim enable command.
Examples The following example shows how to limit the interface bandwidth to 4500 Kbps.
switch# config terminal
switch(config)#
switch(config)# san-ext-tuner enable
switch(config)# exit
switch#
switch# ips netsim max-bandwidth-kbps 4500 ingress gigabitethernet 2/3
Related Commands Command
show ips netsim
ips netsim enable
OL-16217-01, Cisco MDS SAN-OS Release 3.x
ips netsim max-bandwidth-kbps bandwidth ingress gigabitethernet slot/port
Specifies the bandwidth in kilobytes per second. The range is 1000 to
1000000.
Specifies the ingress direction.
Specifies the the slot and port number of the Gigabit Ethernet interface.
Modification
This command was introduced.
Description
Displays a summary of the interfaces that are currently operating in network
simulation mode.
Enables the IP Network Simulator.
ips netsim max-bandwidth-kbps
Cisco MDS 9000 Family Command Reference
11-65