Cisco MDS 9124 - Fabric Switch Reference page 1119

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
show fc-redirect peer-switches
To display all the peer switches in the fabric running FC-Redirect, use the show fc-redirect
peer-switches command.
Syntax Description This command has no arguments or keywords.
Defaults
None.
Command Modes
EXEC mode
Command History Release
3.2(1)
3.3(1a)
Usage Guidelines
This command is used to verify the fabric state and is used for troubleshooting.
Note To find the switch IP address for the list of switch WWNs, use the show cfs peers command.
Examples
The following example displays the peer switches in the fabric running FC-Redirect
switch# show fc-redirect peer-switches
-----------------------------------------------------------------
num
-----------------------------------------------------------------
Table 22-3
Table 22-3
State
Up
Down
Syncing
Error
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show fc-redirect peer-switches
Modification
This command was introduced.
Added the FC-Redirect version of the switch and configuration mode to the
command output.
Switch WWN
1 20:00:00:0d:EC:20:13:00
describes the output for the show fc-redirect peer-switches states.
Show FC-Redirect Peer Switch States
State FCR-Ver Cfg-Mode
UP 2 V2
Description
The peer switch is fully synchronized with the
local switch.
The communication with the peer switch is not
available.
The local switch is synchronizing its
configuration with the peer switch.
Connection with peer switch is not available.
Cisco MDS 9000 Family Command Reference
show fc-redirect peer-switches
22-87