Islb Virtual-Target Name - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

islb virtual-target name

To configure an iSLB virtual target and enter iSLB target configuration submode, use the islb
virtual-target name command. To revert to the default values, use the no form of the command.
Syntax Description
name
all-initiator-permit
initiator
initiator-name
permit
ip address ip-address
pWWN pwwn-id
revert-primary-port
trespass
Defaults
Disabled.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines This command is used to configure a static target for access by iSLB initiators.
OL-16217-01, Cisco MDS SAN-OS Release 3.x
islb virtual-target name name
{all-initiator-permit |
initiator {initiator-name permit | ip address {A.B.C.D permit | X:X:X::X permit}} |
pWWN permit |
revert-primary-port permit |
trespass permit}
islb virtual-target name name
{no all-initiator-permit |
no initiator {initiator-name permit | ip address {A.B.C.D permit | X:X:X::X permit}} |
no pWWN permit |
no revert-primary-port permit |
no trespass permit}
no islb virtual-target name name
Specifies the virtual target name to be used. The minimum length is 16 bytes
and the maximum length is 223 bytes.
Configures all iSLB initiators to access the target.
Configures the iSLB initiator to access the target.
Specifies the initiator name. The minimum length is 16 bytes and the
maximum length is 223 bytes.
Permits access to the specified target.
Specifies the initiator IP address. The format is A.B.C.D or X:X:X::X.
Specifies the pWWN of the Fibre Channel target. The format is
hh:hh:hh:hh:hh:hh:hh:hh.
Reverts to the primary port when it becomes active again.
Enables trespass support.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
islb virtual-target name
11-109