Out-Of-Service Module - Cisco MDS 9124 - Fabric Switch Reference

out-of-service module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
out-of-service module
To perform a graceful shutdown of an integrated crossbar on the supervisor module of a Cisco MDS 9500
Series Director, use the out-of-service module command in EXEC mode.
Syntax Description slot
Defaults None.
Command Modes EXEC.
Command History Release
3.0(1)
Usage Guidelines
Before removing a crossbar from an MDS 9500 Series Director, you must perform a graceful shutdown
of the crossbar.
Enter the EXEC mode out-of-service module command for a graceful shutdown of the integrated
crossbar on the supervisor module in a Cisco MDS 9506 or 9509 Director.
The slot refers to the chassis slot number for Supervisor-1 module or Supervisor-2 module where the
integrated crossbar is located.
To reactivate the integrated crossbar, you must remove and reinsert or replace the Supervisor-1 or
Note
Supervisor-2 module.
For additional information about crossbar management, refer to the Cisco MDS 9000 Family CLI
Configuration Guide.
Examples
The following example shows how to perform a graceful shutdown of the integrated crossbar.
switch# out-of-service module 2
Related Commands Command
out-of-service xbar
show module
Cisco MDS 9000 Family Command Reference
17-26
out-of-service module slot
Specifies the module number. For Cisco MDS 9506 and 9509 Directors, the
range is 1 to 6. For the Cisco MDS 9513 Director, the range is 1 to 13.
Modification
This command was introduced.
out-of-service module slot
Description
Performs a graceful shutdown of an external crossbar switching module in
a Cisco MDS 9513 Director.
Displays the status of a module.
Chapter 17 O Commands
OL-16217-01, Cisco MDS SAN-OS Release 3.x