Member (Zone Configuration And Zoneset-Zone Configuration Submode) - Cisco MDS 9124 - Fabric Switch Reference

Chapter 15 M Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command History Release
1.0(2)
2.1(1a)
3.0(1)
Usage Guidelines Create a zone set zone member only if you need to add member to a zone from the zone set prompt.
Examples
The following example shows how to add a member to a zone called zs1 on VSAN 1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# zone name zs1 vsan 1
switch(config-zone)# member fcid 0x111112
switch(config-zone)#
The following example shows how to add a zone to a zoneset called Zoneset1 on VSAN 1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# zoneset name ZoneSet1 vsan 1
switch(config-zoneset-zone)# member fcid 0x111112
The following example shows how to assign an iSCSI IPv6 address-based membership into a zone.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# zoneset name ZoneSet1 vsan 1
switch(config-zoneset-zone)# member ipv6-address 2001:0DB8:800:200C::417A
The following example shows how to delete the specified device from a zone.
switch(config-zoneset-zone)# no member ipv6-address 2001:0DB8:800:200C::417A
Related Commands Command
zoneset (configuration
submode)
zone name (zone set
configuration submode)
show zoneset
OL-16217-01, Cisco MDS SAN-OS Release 3.x

member (zone configuration and zoneset-zone configuration submode)

Modification
This command was introduced.
Added zoneset-zone configuration submode.
Added the IPv6 IP address format.
End with CNTL/Z.
End with CNTL/Z.
End with CNTL/Z.
Description
Used to specify a name for a zone set.
Configures a zone in a zoneset.
Displays zone set information.
Cisco MDS 9000 Family Command Reference
15-11