Show Ips Ipv6 - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show ips ipv6

To display an IPv6 storage routing table, use the show ips ipv6 command.
Syntax Description neighbors
interface
gigabitethernet
slot/port
prefix-list
route
routers
traffic
Defaults None.
Command Modes EXEC mode.
Command History Release
3.1(0)
Usage Guidelines You can use the show ips ipv6 command to display information about IPv6 routing.
Examples The following example displays IPv6 neighbors information.
switch# show ips ipv6 neighbours interface gigabitethernet 1/1
IPv6 Address
face
fe80::206:d6ff:fe23:4008
GigabitEthernet1/1
The following example displays the IPv6 prefix-list information.
switch# show ips ipv6 prefix-list interface gigabitethernet 1/1
Prefix
2000::
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show ips ipv6 {neighbors interface gigabitethernet slot/port |
prefix-list interface gigabitethernet slot/port |
route interface gigabitethernet slot/port |
routers interface gigabitethernet slot/port |
traffic interface gigabitethernet slot/port}
Displays the IPv6 neighbors table.
Displays the interface status and configuration.
Displays a Gigabit Ethernet interface.
Specifies the slot and port number.
Displays theIPv6 prefix-list table.
Displays the IPv6 route table.
Displays the IPv6 routers table.
Displays the IPv6 traffic table.
Modification
This command was introduced.
Valid Preferred
1000 1000
Age (min) Link-layer Addr
0 0006.d623.4008
Prefix-len Addr
64 2000::205:30ff:fe01:a6be
Cisco MDS 9000 Family Command Reference
show ips ipv6
State Inter
S
22-163