No Fc-Redirect Version2 Enable - Cisco MDS 9124 - Fabric Switch Reference

Chapter 16 N Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

no fc-redirect version2 enable

To disable the version2 mode in FC-Redirect, use the no fc-redirect version2 enable command in
configuration mode.
Syntax Description This command has no arguments or keywords.
Defaults
None.
Command Modes
Configuration mode
Command History Release
3.3(1a)
Usage Guidelines
We recommend that you not disable version2 mode in FC-Redirect because it disables version2 mode
thoughtout the fabric.
Examples The following example shows how to disable version2 mode in FC-Redirect.
switch# no fc-redirect version2 enable
switch(config)# no fc-redirect version2 enable
WARNING: This command will disable Version2 mode throughout the fabric.
Do you want to continue? (Yes/No) [No] Yes
Before proceeding further, Please check the following:
Do you want to continue? (Yes/No) [No] Yes
OL-16217-01, Cisco MDS SAN-OS Release 3.x
no fc-redirect version2 enable
Modification
This command was introduced.
This is NOT a recommended step.
1) There are No FC-Redirect configurations in the fabric.
You can use the command 'show fc-redirect configs' for the
purpose.
2) All the switches in the fabric are seen in the output of
'show fc-redirect peer-switches' command and are in 'UP' state.
3) All switches in the fabric are running SanOS version 3.3.x or
higher.
4) Please make sure the Fabric is stable ie.,
No fabric changes/upgrades in progress
no fc-redirect version2 enable
Cisco MDS 9000 Family Command Reference
16-7