Debug Wr-Reg - Cisco MDS 9124 - Fabric Switch Reference

Chapter 6 Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

debug wr-reg

To enable debugging for the list of devices using the write-register feature, use the debug wr-reg
command in EXEC mode. To disable a debug command, use the no form of the command or use the no
debug all command to turn off all debugging.
Syntax Description device-name
register-address
Defaults Disabled.
Command Modes
EXEC mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example displays the system output when the debug wr-reg command is issued:
switch# debug wr-reg
Related Commands Command
no debug all
OL-16217-01, Cisco MDS SAN-OS Release 3.x
debug wr-reg [device-name | register-address]
no debug wr-reg [device-name | register-address]
Modification
This command was introduced.
Description
Disables all debugging.
Specifies the device name for the required device.
Specifies the register address for the required device.
Cisco MDS 9000 Family Command Reference
debug wr-reg
6-129