Initiator - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

initiator

To configure the initiator version and address, use the initiator command IKE configuration submode.
To revert to the default, use the no form of the command.
Syntax Description
version
address ip-address
Defaults IKE version 2.
Command Modes IKE configuration submode.
Command History Release
2.0(x)
Usage Guidelines
To use this command, the IKE protocol must be enabled using the crypto ike enable command.
Examples The following example shows how initiator information for the IKE protocol.
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)# initiator version 1 address 10.1.1.1
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
OL-16217-01, Cisco MDS SAN-OS Release 3.x
initiator version version address ip-address
no initiator version version address ip-address
Specifies the protocol version number. The only valid value is 1.
Specifies the IP address for the IKE peer. The format is A.B.C.D.
Modification
This command was introduced.
Description
Enters IKE configuration mode.
Enables the IKE protocol.
Cisco MDS 9000 Family Command Reference
initiator
11-5