Passive-Mode - Cisco MDS 9124 - Fabric Switch Reference

passive-mode

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
passive-mode
To configure the required mode to initiate an IP connection, use the passive-mode command. To enable
passive mode for the FCIP interface, use the no form of the command.
Syntax Description
This command has no keywords or arguments.
Defaults
Disabled
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines
Access this command from the
By default, the active mode is enabled to actively attempt an IP connection.
If you enable the passive mode, the switch does not initiate a TCP connection and merely waits for the
peer to connect to it.
Examples The following example enables passive mode on an FCIP interface.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# passive-mode
Related Commands Command
show interface fcip
Cisco MDS 9000 Family Command Reference
18-2
passive-mode
no passive-mode
Modification
This command was introduced.
Description
Displays an interface configuration for a specified FCIP interface.
submode.
switch(config-if)#
Chapter 18
OL-16217-01, Cisco MDS SAN-OS Release 3.x
P Commands