Ivr Zone Name - Cisco MDS 9124 - Fabric Switch Reference

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ivr zone name

To configure a zone for Inter-VSAN Routing (IVR), use the ivr zone name command. To disable a zone
for IVR, use the no form of the command.
Syntax Description
ivz-name
Defaults None.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines This command enters IVR zone configuration submode.
Examples The following command enters the configuration mode, enables the IVR feature, creates an IVZ, and
adds a pWWN-VSAN member.
switch# config terminal
switch(config)# ivr enable
switch(config)# ivr zone name Ivz_vsan2-3
switch(config-ivr-zone)# member pwwn 21:00:00:e0:8b:02:ca:4a vsan 3
Related Commands Command
show ivr
OL-16217-01, Cisco MDS SAN-OS Release 3.x
ivr zone name ivzs-name
no ivr zone name ivz-name
Specifies the IVZ name. Maximum length is 59 characters.
Modification
This command was introduced.
Description
Displays IVR feature information.
Cisco MDS 9000 Family Command Reference
ivr zone name
11-143