Show Rmon - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show rmon

To display the remote monitoring (RMON) configuration or onboard log, use the show rmon command.
Syntax Description
alarms
events
hcalarms
logs
Defaults None.
Command Modes EXEC mode
Command History Release
2.0(x)
2.1(2)
3.0(1)
Usage Guidelines
None.
Examples The following example displays the configured RMON alarms.
switch# show rmon alarms
Alarm 20 is active, owned by test
Monitors 1.3.6.1.2.1.2.2.1.16.30 every 30 second(s)
Taking delta samples, last value was 17
Rising threshold is 15, assigned to event 1
Falling threshold is 0, assigned to event 0
On startup enable rising or falling alarm
The following example displays the configured RMON events.
switch# show rmon events
Event 4 is active, owned by administrator@london_op_center
Description is WARNING(4)
Event firing causes log and trap to community public, last fired 03:32:43
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show rmon {alarms | events | hcalarms | logs}
Displays the configured 32-bit RMON alarms.
Displays the configured RMON events.
Displays the configured 64-bit high-capacity (HC) RMON alarms.
Displays the RMON event logs.
Modification
This command was introduced.
Added the logs option.
Added the hcalarms option.
Cisco MDS 9000 Family Command Reference
show rmon
22-295