Iscsi Interface Vsan-Membership - Cisco MDS 9124 - Fabric Switch Reference

iscsi interface vsan-membership

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi interface vsan-membership
To configure VSAN membership for iSCSI interfaces, use the iscsi interface vsan-membership
command. Use the no form of this command to disable this feature or to revert to factory defaults.
Syntax Description
This command has no arguments or keywords.
Defaults
Disabled.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines
If the iscsi interface vsan-membership command is disabled, you will not be able to configure iSCSI
VSAN membership.
Changing the VSAN membership, the forwarding mode, and the authentication of an iSCSI interface that
Caution
is part of an iSLB VRRP group impacts load balancing on the interface.
For additional information, refer to the "Configuring iSCSI" chapter of the Cisco MDS 9000 Family CLI
Configuration Guide.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following command enables the iSCSI interface VSAN membership.
switch# config terminal
switch(config)# iscsi interface vsan-membership
The following command disables the iSCSI interface VSAN membership (default).
switch(config)# no iscsi interface vsan-membership
Related Commands
Cisco MDS 9000 Family Command Reference
11-94
iscsi interface vsan-membership
no iscsi interface vsan-membership
Modification
This command was introduced.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands