Show Sprom - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show sprom

Command
span session source
interface
To display vendor ID, product component attributes, serial number information that can be used to track
field replacable units, use the show sprom command.
Syntax Description
backplane
backplane-index
clock
clock-module-index
fan
mgmt-module
module module-number
sprom-index
powersupply
powersupply-index
sup
Defaults None.
Command Modes EXEC mode.
Command History Release
1.0(2)
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Description
Configures the SPAN traffic in both ingress (rx) and egress (tx) directions.
show sprom {backplane backplane-index |
clock clock-module-index |
fan |
mgmt-module |
module module-number sprom-index |
powersupply powersupply-index |
sup}
Displays attributes that can be used to uniquely identify a switch. The range
is 1 to 2.
Displays attributes of the clock module. There are two clock modules in a
switch. This module is absent in MDS9216 type switch. The range is 1 to 2.
Displays attributes that uniquely identified fan.
Displays attributes of management module. This module is only present in
MDS9216 type switch.
Displays Vendor ID, product's component attributes for the given switching
module. There can be up to 4 sub-components in a module. Each of them
will have a SPROM associated with it.
Displays attributes of the first or the second power-supply. This contains
information about the powersupply capacity in watts when it is used in
110Volts and 220Volts respectively. This information is used for
power-budget allocation. The range is 1 to 2.
Displays Vendor ID, product's component attributes for the current
supervisor module
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
show sprom
22-335