Interface Bay | Ext - Cisco MDS 9124 - Fabric Switch Reference

interface bay | ext

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
interface bay | ext
To configure a Fibre Channel interface on a Cisco Fabric Switch for HP c-Class BladeSystem and on a
Cisco Fabric Switch for IBM BladeCenter, use the interface bay or interface ext command in
configuration mode.
Syntax Description
bay port | ext port
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
3.1(2)
Usage Guidelines
None.
Examples The following example configures Fibre Channel interface bay2 and enters interface configuration
submode.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# int bay 2
switch(config-if)#
Related Commands Command
show interface
Cisco MDS 9000 Family Command Reference
11-22
interface {bay port | ext port}
Configures a Fibre Channel interface on a port. The range is 0 to 48.
Modification
This command was introduced.
Description
Displays an interface configuration for a specified interface.
Chapter 11
OL-16217-01, Cisco MDS SAN-OS Release 3.x
I Commands