Job Name - Cisco MDS 9124 - Fabric Switch Reference

job name

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
job name
To assign a job to a command schedule, use the job name command. To remove the job, use the no form
of the command.
Syntax Description
job-name
Defaults None.
Command Modes Scheduler schedule configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the command scheduler must be enabled using the scheduler enable command.
You can configure multiple jobs in a command schedule.
Examples The following example shows how to specified the job for a command schedule.
switch# config terminal
switch(config)# scheduler schedule name MySchedule
switch(config-schedule)# job name MyJob
Related Commands Command
scheduler enable
scheduler schedule name
show scheduler
Cisco MDS 9000 Family Command Reference
12-2
job name job-name
no job name job-name
Modification
This command was introduced.
Specifies the job name for the command schedule to run.
Description
Enables the command scheduler.
Configures a schedule for the command scheduler.
Displays scheduler information.
Chapter 12
OL-16217-01, Cisco MDS SAN-OS Release 3.x
J Commands